Researchers in Italy have investigated whether low-power microwave drying could accelerate the preparation of cannabis plant samples for forensic THC analysis, potentially reducing laboratory processing time.
The study, published online on 16 November 2026 in the Journal of Forensic Sciences, examined how microwave drying compares with conventional air and oven drying when measuring neutral tetrahydrocannabinol (THC).
Forensic laboratories may need to determine THC concentrations in seized cannabis material, including measurements expressed relative to the sample's dry weight.
However, preparing plant material for analysis can be time-consuming because moisture must be removed before reliable dry-weight measurements can be obtained.
Researchers Matteo Nioi, Ivana Mulano, Alessia Maccioni and Giampiero Cortis conducted a proof-of-concept investigation involving fresh material collected from 20 cannabis plants.
Samples from each plant were divided into matched portions and subjected to three drying approaches: ambient air drying, laboratory oven drying and low-power microwave drying.
The oven treatment used a temperature of 80°C for 10 minutes, while microwave drying was performed at 70 watts for approximately two to three minutes.
Following sample preparation, the researchers used gas chromatography–mass spectrometry (GC-MS) for identification and gas chromatography with flame ionization detection (GC-FID) for quantification.
The investigation specifically measured neutral THC. It did not determine tetrahydrocannabinolic acid (THCA) or total potential THC.
The reported average neutral THC concentrations were 0.898% for air-dried material, 0.829% for oven-dried samples and 0.802% for microwave-dried samples.
Statistical analysis identified differences among the drying methods.
Nevertheless, the microwave and oven measurements showed relatively close agreement under the experimental conditions.
The mean difference between microwave and oven drying was approximately −0.027 percentage points.
The researchers also reported a high intraclass correlation coefficient of 0.975, indicating strong agreement between the two measurement approaches within the tested sample set.
However, a formal equivalence test did not demonstrate that the methods were interchangeable within the predefined margin of ±0.05 percentage points.
This distinction is important because close agreement in a small experimental study does not automatically establish that a method is suitable for routine forensic casework.
The findings suggest that low-power microwave drying could offer a faster approach for preliminary analysis, particularly where sample preparation time affects laboratory efficiency.
However, the study involved only 20 plants and did not evaluate every factor relevant to confirmatory forensic testing.
The researchers identified several areas requiring further investigation, including residual moisture measurement, temperature monitoring, broader cannabinoid profiling and comprehensive analytical validation.
The method therefore remains experimental and should not be considered a validated replacement for established forensic preparation procedures.
The study highlights how relatively simple laboratory workflow changes may improve analytical efficiency, while reinforcing the need to demonstrate measurement reliability before introducing new methods into forensic casework.